A.N. Creation Office ยท Project recordPlastic-base snap mousetrap. Example (illustrative figures are marked).

Decision log

datedecisionreasonstatus
2026-10-12Plastic base instead of woodWood splits and is hard to clean. A molded base can carry the bait cup and a finger guard in the same part. The trigger plate is plastic too, in its own mold. The bail, the spring, and the staple stay metal.accepted
2026-10-13Nylon 6/6 for the base and the trigger plateBetter impact and moisture resistance than polypropylene for barn use. Both plastic parts use this resin. The base mold and the trigger mold on the cost sheet are this call. Risk table F2 is the swell, accepted on one line.accepted
2026-10-14Amortize tooling over 2 years and 100,000 traps50,000 a year for 2 years is 100,000. The inventor wants to see the per-trap cost before committing to a 3-year spread, and wants that number under $0.40. Accepted means the cost sheet uses 100,000. It does not mean the $1.47 result is approved. The base mold alone is $0.85 a trap at this volume.accepted
2026-10-15Keep the classic wire bail, spring, and steel stapleExisting suppliers already make this bail. A new shape would need a new spring tool. The spring and the staple stay music wire and steel. They are purchased. They are not molded. The staple is pressed in during assembly.accepted
2026-10-15Approve the project charter, revision AFact-finding is done: the charter sets the scope, the $0.45 landed-cost target, the milestones and the $8,000-$12,000 budget through design freeze. The molds are in the plan but not funded; ECN-001 proposes making them conditional.accepted

Readable copy built by record-view.py from the sheet of the same name. The sheet is the record.