Procedure: Manufacturing cells and work design (b-manufacturing). Revision 2 — October 18, 2026. Index: https://ancreationoffice.com/sop.txt Source: standard lean practice and ergonomics guidance; Mike: cell manufacturing, the horseshoe (U-shaped cell), the work cell rules and ergonomics are well documented (Mike's notes, kept private). Tier: deep, book-based. Related: guide/toolbox-improvement.txt; manufacturing.txt. Read this when a new product goes into production, an assembly or secondary operation is laid out, or a line can't keep up. METHOD 1. Takt time: available working time divided by customer demand in that time. It is the pace the cell must meet. 2. Check every machine in the cell can meet takt, counting changeovers, load and unload, and downtime. 3. Work content: time every manual step (several cycles each). Operators needed = total work content / takt; then balance the steps across operators. 4. Layout: a U-shaped (horseshoe) or C-shaped cell, equipment in process order, so one operator can work both sides with little walking; a straight line where the product is too big or needs access from all sides. Keep the cell at human scale. 5. Standard work per operator: the steps, their order, the time, and the parts on hand. 6. Ergonomics: standing or sit-stand work, parts and tools within easy reach, no lifting or reaching that overloads; check repetitive tasks with the NIOSH ergonomics tools. Reducing overburden is part of reducing waste. 7. Mistake-proof the steps that can go wrong, and set the checks in the control plan (sop-quality.txt). 8. Measure after start: output per hour against takt, scrap, and where people wait or walk. SOURCES (library) lei-lexicon (takt, cells, standard work), lean-six-sigma-pocket-toolbook, niosh-ergonomics-overview, niosh-tools, niosh-hand-tools, ansur2-design-data, mep, wmep-wisconsin, asq-mistake-proofing. PRODUCES A cell plan: takt, machine check, time study, operator count and balance, layout sketch, standard work sheets, ergonomic checks, and the measures to watch.