Procedure: Tolerance stacks and print review (b-tolerance-gdt). Revision 2 — October 18, 2026. Index: https://ancreationoffice.com/sop.txt Source: standard practice (ASME Y14.5, stack methods); Mike: each part can be off by its own amount, independent of the others, and the parts must still assemble (Mike's notes, kept private). Calculation: https://github.com/mminwi/an-creation-office/blob/main/specialists/calcs/tolerance_stack.py. Tier: deep, book-based. Read this when parts must fit together, a fit problem shows up in assembly, or a print is being reviewed. METHOD 1. Draw the loop: start at one side of the gap that matters, walk part to part around to the other side, writing each dimension with its direction (+ or -). 2. For each dimension: nominal, plus and minus tolerance. For molded parts include shrink and warp variation; ask the molder what a process holds (sop-scientific-molding.txt). 3. Run the three methods (tolerance_stack.py): - Worst case: everything at its worst limit at once. Guarantees assembly; often too tight to make economically. - RSS (root sum square): assumes independent, roughly normal, centered parts; a small share may fall outside. - Monte Carlo: random parts; reports the share outside the gap limits, and works with uneven tolerances and other distributions. 4. Read the contributors: the dimensions that carry most of the variance are where to tighten, or to redesign the loop shorter. 5. Decide: worst case where failure to assemble is unacceptable (safety, field fit); statistical where volume and process control justify it. Write down which, and why. 6. Print review: datums that match how the part is located in assembly and in inspection; every feature controlled; GD&T per ASME Y14.5 (ISO 1101 for ISO-system suppliers; Y14.41 for model-based definition). SOURCES (library) Books (the depth): fischer-tolerance-stackup (Fischer, Mechanical Tolerance Stackup and Analysis), drake-tolerancing-handbook (Drake, Dimensioning and Tolerancing Handbook). Standards: asme-y14-5, asme-y14-5-1, asme-y14-41, iso-1101; nist-tolerance; method overviews: tolerance-stack-methods. PRODUCES A stack report per gap: the loop sketch, the dimension table, the three results, the contributors, the decision and its reason. Results are proposed; the designer confirms.